(405) 273-8363
New Store Hours
Open: 8:00 a.m. to 5 p.m. Tue - Fri.
Closed: Sat, Sun & Mon.
Open: 8:00 a.m. to 5 p.m. Tue - Fri.
Closed: Sat, Sun & Mon.
Installing a Quickseam Pre-Molded Pipe Boot or Flashing
Step 1 -Ensure the liner is dry and free of mud or other contaminants.
Step 2 -Using scissors, cut the pipe boot at the vertical rib that is just smaller than the pipe’s outside diameter.
Step 3 -Using a scrubber pad and holder; apply QuickPrime Plus primer to a 14” diameter area around the pipe. Make sure to extend primer past the adhered pipe boot flange area.
Step 4 -Place a continuous bead of Water Block Seal at the proper elevation on the boot.
Step 5 - Test the primer flash-off by touching the primed area with your finger and pushing forward at an angle. The primer should not string as your finger is moved up and away.
Step 6 - Slide the pipe boot down over the pipe until the flange of the pipe boot contacts the pre-primed PondGard panel.
Step 7 - Remove the release paper.
Step 8 - Smooth the pipe boot flange onto the PondGard panel.
Step 9 - Using a hand roller; roll the pipe boot flange to insure adhesion to the PondGard panel.
Step 10 - Attach and tighten the stainless steel clamp to the pipe boot rib that grips the pipe.
Step 11 - Apply a continuous bead of Lap Sealant HS or All Purpose Sealant over the top edges and the edges at the base of the boot.
Step 12 - Trim the excess metal from the clamp.
This Detail featured these Firestone Specialty Products:
• PondGard EPDM Rubber Membrane
• QuickSeam Pipe Flashing
• QuickPrime Plus Primer
• QuickScrubber
• Hand roller
• Water Block Seal
• Lap Sealant HS
• All Purpose Sealant
• QuickSeam Pipe Flashing
• QuickPrime Plus Primer
• QuickScrubber
• Hand roller
• Water Block Seal
• Lap Sealant HS
• All Purpose Sealant